Folia Medica Indonesiana
ISSN 0303-7932
Vol. 43 / No. 1 / Published : 2007-01
TOC : 7, and page :32 - 38
Related with : Scholar Yahoo! Bing
Original Article :
Microscopic picture and water content in dentin analysis of bonding agent bond to dentin surface an evaluation of various humidity
Author :
- Adioro Soetojo*1
- Department of Conservative Dentistry Airlangga University School of Dentistry
Abstract :
The bond strength of bonding agent (HEMA based) in dentin surface can occur if collagen fibril is in permeable condition. This condition is influenced by the humidity in teeth surface, water content in dentin and the bonding resin insertion to dentin tubule. This research is aimed to identify the microscopic picture of tags resin and hybrid layer thickness and water content in dentin in relation to humidity in dentin surface. Bovine incisor was cut and shaped with diamond disk until reaching dentin area. After cutting was completed, dentin was cleaned and soaked into physiologic salt for 24 hours. Then it was dried with tissue paper for 5 minutes and put into desiccators for 1 hour. Soon after it is completed, it is measured and put into oven in 70°C to reach constant weight. From this process, we could reveal water content in dentin. Sample preparation for SEM: Cavity preparation was made to the tooth in labial area in circle shapewith 5 mm diameter, 2 mm depth. Then etching was done with 37% phosphoric acid for 15 seconds and washed with 20 cc distilled water, and dried with cotton pellets. Then, it was put into desiccators for 1 hour. After it was completed, self cured acrylic ingredient was applied. In the middle of cavity, the tooth was cut. The cut tooth is examined for the hybrid layer thickness and tags resin length with scanning electronic microscope. The result data were analyzed with one-way ANOVA test at 95% confidence level and continued with LSD test. This research result showed that in 60% water content humidity of dentin was at the lowest point and 90% was at the highest point. At 60% to 90% humidity, mean score of hybrid layer, tags resin length showed there was no significant difference. In conclusion, the higher the humidity of ground teeth area, the higher the water content in dentin. There was no bonding microscopic picture between bonding dentin (HEMA) and collagen in humidity increasing.
Keyword :
dentin bonding agent, humidity, water content, tags resin, hybrid layer,
References :
- KJ Anusavice, (2003). Phillip’s Science of Dental Materials. Philadelphia-London-Toronto : WB Saunders Co.
- S Adioro, (2006). Kekuatan perlekatan antara bahan bonding HEMA dengan kolagen dentin pada berbagai kelembaban. Surabaya : Airlangga University
- C Besnault, (2001). Influence of a simulated oral environmental on dentin bond strength of two adhesive systems. no info : Am J Dent
- JP Attal, (2001). Influence of a simulated oral environmental on dentin bond strength of two adhesive systems. no info : Am J Dent
- MG Brackett, (2006). Microleakage of class V resin composites placed using self-etching resins. no info : Quintess Int
- WW Brackett, (2006). Microleakage of class V resin composites placed using self-etching resins. no info : Quintess Int
- LD Haish, (2006). Microleakage of class V resin composites placed using self-etching resins. no info : Quintess Int
- L Breschi, (2002). High resolution SEM evaluation of dentin etched with maleic and citric acid. no info : Dent Mat
- M Falconi, (2002). High resolution SEM evaluation of dentin etched with maleic and citric acid. no info : Dent Mat
- Y Chiba, (2004). Influence of environmental conditions on dentin bond strengths of one application adhesive systems. no info : Oper Dent
- BH Cho, (2004). Effect of the acetone content of single solution dentin bonding agents on the adhesive layer thickness and the microtensile bond strength. no info : Dent Mat
- SH Dickens, (2004). Effect of the acetone content of single solution dentin bonding agents on the adhesive layer thickness and the microtensile bond strength. no info : Dent Mat
- S Cohen, (2002). Pathways of the Pulp. St Louis-London-Philadelphia : Mosby Inc
- RC Burns, (2002). Pathways of the Pulp. St Louis-London-Philadelphia : Mosby Inc
- RG Craig, (2002). Dental Materials. Properties and Manipulation. Baltimore-Boston-Carlsbad : Mosby Inc
- JM Powers, (2002). Dental Materials. Properties and Manipulation. Baltimore-Boston-Carlsbad : Mosby Inc
- JC Wataha, (2002). Dental Materials. Properties and Manipulation. Baltimore-Boston-Carlsbad : Mosby Inc
- FE Feninat, (2002). A tapping mode AFM study of collaps and denaturation in dentinal collagen. no info : Dent Mat
- TH Ellis, (2002). A tapping mode AFM study of collaps and denaturation in dentinal collagen. no info : Dent Mat
- E Sacher, (2002). A tapping mode AFM study of collaps and denaturation in dentinal collagen. no info : Dent Mat